2nd Day - 5/19

 Today, I got in pretty late at around 10:45 and the office was locked so I resorted to working in the lab with the slot die coater and the xyz robot.

I translated the entire slot die coater manual  and did research on scribing before lunch. 

Turns out, the slot die coating demo didn't go to plan as the manual that they gave didn't have step by step instructions, just how to use each component.

After the demo, I tried to figure out how to use the robot, but I couldn't use the software and there was also no guide for the software.

I then later did more research on exactly how the P1, P2, P3 scribing is done.

I need to figure out where exactly I should make a bracket, and try and 3d print a bracket or ask the shop to make a bracket.